Our Anarchy Airboat kit is made from laser cut high grade 1/4" Sande plywood for the inside frame and motor mount, and 1/16" 2-ply high grade model
wood for the outside skin. (assembly required). Building the kit is very easy thanks to the laser cut precision, good for first timers, every frame piece
snaps together in place thigh. Rudder horn and push rod included.
Motor mount "Electric": Designed with universal mount holes and fits most of the brushless outrunners motors out there.
Radio Compartment "Electric": Requires (1) standard size servo for steering, a 1/16" laser cut clear acrylic cover is included with foam gasket. Battery
compartment area is 49mm wide, 28.5mm tall and 146mm long.
Propeller: Propeller max diameter is 6" (propeller not included)
Recommended brushless setup: 2,200kv-6 outrunner motor, 6" x 4" APC propeller, 30amp ESC, 30C or more discharge rate 3S lipo.
Weight and Size "Electric":
Built and sealed without electronics = 1.27lbs
Hull measurements = 16.75" x 10" x 1.75"
Hull w/rudders measurements = 19.5" x 10" x 6.5"
Things that you need: (not included)
1) Glue (CA, Epoxy)
2) Small clamps (to hold the bottom and sides while they bond)
3) Sealer (Epoxy, Silicone, Paint, ETC)
4) Brushless outrunner motor / 6" x 4" Propeller
5) Brushless ESC
6) Radio, Servo, RX "Please read on the compartment area"
7) Battery
wood for the outside skin. (assembly required). Building the kit is very easy thanks to the laser cut precision, good for first timers, every frame piece
snaps together in place thigh. Rudder horn and push rod included.
Motor mount "Electric": Designed with universal mount holes and fits most of the brushless outrunners motors out there.
Radio Compartment "Electric": Requires (1) standard size servo for steering, a 1/16" laser cut clear acrylic cover is included with foam gasket. Battery
compartment area is 49mm wide, 28.5mm tall and 146mm long.
Propeller: Propeller max diameter is 6" (propeller not included)
Recommended brushless setup: 2,200kv-6 outrunner motor, 6" x 4" APC propeller, 30amp ESC, 30C or more discharge rate 3S lipo.
Weight and Size "Electric":
Built and sealed without electronics = 1.27lbs
Hull measurements = 16.75" x 10" x 1.75"
Hull w/rudders measurements = 19.5" x 10" x 6.5"
Things that you need: (not included)
1) Glue (CA, Epoxy)
2) Small clamps (to hold the bottom and sides while they bond)
3) Sealer (Epoxy, Silicone, Paint, ETC)
4) Brushless outrunner motor / 6" x 4" Propeller
5) Brushless ESC
6) Radio, Servo, RX "Please read on the compartment area"
7) Battery
Copyright © 2011 C Laser Designs
| Thanks to 2manytoyZ for the video and pictures http://www.2manytoyz.com/ |
2manytoyZ Anarchy Airboat Review
(Requires Assembly)
| THE CURRENT LEAD TIME FOR THIS AIRBOAT IS 3-4 WEEKS |
 |
 |
 |
 |
 |
 |
 |
 |
Anarchy Airboat